Watsen Design on XB12R/S Tail

[Doc13]

I thought I would post this up...the blinkers are expensive so people tend to stray against. I got nothing but top notch customer service from the team up in Canada...be patient and you will be happy with the result.

I had to drill the front fairing stay once on each side...super simple...in order to keep from drilling the fairing I just took some off the stay on the back side so I could actually tighten the nut down for the fronts. The rears...I mount my plate up underneath so the tail chop I have has 4 bolt holes vacant. I opened one of them up to make room for the wires and just bolted them in. Here are some pics.

He also builds in resistors so updating the flasher is unnecessary. The signals are guarunteed for life...if you have issues you just contact them for replacements as long as you don't modify his wiring as is directed when you order the product.

 

[Doc13]

By the way these are the WD universal style (ST)

Watsen Design Universal Products

 

[RedWhiteandBuell]

[up][up] These turn signals are top notch!! I have a set of his flushmounts on my 600RR. They are VERY bright and they fit perfectly in the fairings and he did a great job on color matching them to the RR Graffiti paint color!!

I will be doing two universal sets on my 'Bolt sometime as well. Never thought about mounting them on the rear like you did though. I was just going to put them on the stock turn signal location on the tag bracket.

Looks good!

 

[Doc13]

Well with the chopped tail being an aftermarket piece, it doesn't have mounts for the stock blinkers...you're supposed to wire them to the sides of your license plate mount. I thought about drilling the sides but there wasn't really a smooth place on the side that wouldn't require modification internal to the tail. My only issue doing it under the tail was visibility but I've had no issues thus far and honestly they seem clear as day to me. That many LED's staring at you...lol