WTB XB Primary Cover

[Hydrophilic]

Like the title says looking for a primary cover for my 07 fire bolt. The bolt holding the shinter in place sheared off and cracked the cover.

Thanks

 

[Mope]

We've played this game a bunch and I'm not going to search down the rabbit hole on my phone........what years had what bushing sizes? I've got a few primary covers and am unloading xb parts, but I'd want to get a measurement to make sure one would suit your needs.
I believe the part numbers are all the same.

 

[loose1]

03-05 small
06+ larger

and blast will only fit a blast

 

[Hydrophilic]

Great, looks like I have the larger. Mope I messaged you if you've got one let me know.

 

[Hydrophilic]

Haven't heard anything from Mope so just checking if anyone else might have one that they could let go of before I get a new one off eBay.

 

[Mope]

I must not have been clear when I asked for your bushing spec.........here, and via the PM conversation. And I never got a reply.

 

[Mope]

ok.....i've never really looked that close at the shift shaft size/bushings on the covers. interesting.

I've got two covers with bushings on the inside measuring approx 13.7 mm
and two covers with no interior bushings; when measured at the exterior they're approx 12.2 mm

 

[loose1]

Flip the caliper over. That side is for measuring Id's

 

[Mope]

****....is that how it works?

if you want to be able to take a picture from this side, you've got to flip it back over (and qualify with the word 'approximately')!