XB12Scg about to getweir'd project thread

[34nineteen]

Well, I half failed... which is still a fail. I found ONE pushrod! I thought I had either 3 or 5 and went through ALL of my Buell parts looking for them... unfortunately one isnt going to do you any good.

I did some research on them and it looks like all XB's used the same pushrods, as did the 04-up Sportsters. So, it should be a cheap and easy e-Bay find. Like this: https://www.ebay.com/itm/125458155256

BTW, the intake side is P/N 17909-02, exhaust is P/N 17908-02. Also, the lengths are 10.780" exhaust and 10.726" intake in case you get some missing the paint marks.


PS. CoOter is a cheap and easy e-Bay find.

 

[Cooter]

YOU'RE a push rod.











:angel:

 

[34nineteen]

YOU'RE a push rod.

Well, thats what the ladies call me.

 

[getweir'd]

Well, I half failed... which is still a fail. I found ONE pushrod! I thought I had either 3 or 5 and went through ALL of my Buell parts looking for them... unfortunately one isnt going to do you any good.

I did some research on them and it looks like all XB's used the same pushrods, as did the 04-up Sportsters. So, it should be a cheap and easy e-Bay find. Like this: https://www.ebay.com/itm/125458155256

BTW, the intake side is P/N 17909-02, exhaust is P/N 17908-02. Also, the lengths are 10.780" exhaust and 10.726" intake in case you get some missing the paint marks.


PS. CoOter is a cheap and easy e-Bay find.

Thanks so much! Just purchased those. Very reasonable for a full engine set.

 

[34nineteen]

Keep up posted on the results. :up:

 

[kz6fittycent]

34nineteen reports back: "eBay push rods were made of lead. Used pencils instead."