another welding question

[jakestolar]

Mig is typically 75/25 CO2/Argon

I thought it was 75% argon 25% CO2

BuellyBagger I will see if I can get you some pictures tomorrow I just closed up shop and if I go back out I wont come back in for a couple of hours

 

[BuellyBagger]

/\ i understand completely

 

[jakestolar]

Link to install instructions Here

Here is a picture

and here is the link to the welder I am thinking of picking up here

 

[d_adams]

I thought it was 75% argon 25% CO2

You're right (I don't use a mig). I know the mix was 75/25 and there's a tri-mix as well. I didn't look up the actual mix, was just guessing. There's actually a pretty wide variety of mixes available, 75/25 is the most common.

 

[BuellyBagger]

well it definetly makes it easier that its a convertable (thats what the instructions are for ne way) the reinforcement plates i think would be easily installed using your welder as per the instructions. welding the actual tubes might be best done with a 220 mig or a tig welder.

 

[jakestolar]

Yup she is a vert that is why the cage is going in. Here is a little mock up

Trying to figure out what to do with this light bar..

 

[jakestolar]