Anyone 08-09 using IDS ECU?

[mpkopish]

" IMO, ECMSpy and TunerPro were both built in mind of building fuel injection programs from scratch. If you have a turbo, cams, headwork, or all of the above, use one of those programs. ECMDroid is meant for diagnostics, datalogging and installing pre-existing tunes.
However, you are able to "tune" your bike with ECMDroid using your Buelltooth bluetooth dongle by utilizing a O2 sensor (wideband), datalogging the info, and using the VE analyses section of MegaLog Viewer to build a fuel map with whatever target AFV's you wish."

cool....what is the cleanest way to add the additional wire on the o2 sensor? Also, did my video come thru on the site? Had a hard time loading it for some reason...Thanks,

 

[Cooter]

cool....what is the cleanest way to add the additional wire on the o2 sensor?

What? Why?

 

[mpkopish]

What? Why?

The Narrow band o2 is one wire, and isnt the wideband o2 more than one wire?

 

[Cooter]

Yes. But you aren't buying a WB O2 and building the emulator circuit board from scratch.
The single wire NB is simply the input wire to the ECM, The 3 wire WB sensor is for the pre-heater. 5V-signal-ground.

You would be buying a WB O2 kit and using the stock O2 input to the ECM as both the datalogging record and the NB input when CL in enabled. No splicing needed.

There is another open pin on the ECM for a separate pass-through but unnecessary for what you are doing.

 

[mpkopish]

Yes. But you aren't buying a WB O2 and building the emulator circuit board from scratch.
The single wire NB is simply the input wire to the ECM, The 3 wire WB sensor is for the pre-heater. 5V-signal-ground.

You would be buying a WB O2 kit and using the stock O2 input to the ECM as both the datalogging record and the NB input when CL in enabled. No splicing needed.

There is another open pin on the ECM for a separate pass-through but unnecessary for what you are doing.

ok, got it...Thanks,