anyone know where to get the tail lift brackets from in usa

Buellxb Forum

Help Support Buellxb Forum:

08supermoto

Well-known member
Joined
Aug 9, 2010
Messages
106
i no this might b a soft spot for some meaning looked hard found nothing , so if anyone knows where or if somebody is getting rid of theres i have a
2006 xb12r fb i want the lift kit bad [bad]
ps i would rather get them from america im a
new jersian we dont trust nobody no what i mean lol
 
somebodies gotta have some no how or where i can get these brackets,the bikes look so much better with it
 
I don't think anyone actually makes a kit for the xbr. I know I've seen two people on here make them, but then you still have to figure out what to do with that gap between the frame and the tail. Most people are just taking a short piece of steel, drilling 2 holes in each, and bolting one end to the frame and the other to the subframe.
 
thanks bro for the reply ,tho i c this must be hard to get pieces , i am a stunter that loves to drag his knees in the corners ,i hope once i get it that it doesnt take away from the bike in any way
 
I don't think it'll hurt anything. The front of your seat will be the same height, I'll just raise the rear of your seat a little, and put it at more of an aggressive angle so you'll probably notice yourself sliding forward a little bit.
 
Where you at in Jersey?

Make your own.... you can set your own height that way. 14 gauge metal bar, with different heights drilled in. Once you get the subframe to the right height, put the plastic on and just trim little by little till it doesnt rub your frame. The seat is where you have the problem. I lifted mine and my seat never fit just right. So i removed the lift, but im working on another rear end entirely for a slick looking but still stock appearing lift.
That same shop.frank-parts has a complete lift with plastics for the xb9/12r's, its $$$$ but its nice looking.

Good luck[up]
 
Back
Top