buell blast ignition fuse

[joncochino]

My 7.5amp ignition fuse keeps blowing.I tracked as many wires as i could,and didn't see any exposed wires.What could cause this.

 

[ezblast]

Did you test at the key wire junction?

 

[joncochino]

i didn't see any loose,or exposed wires there.

 

[Builtdesign]

I think he means test it with a multimeter, as the switch inside may be bad.

 

[ezblast]

Concur -

 

[joncochino]

hmm,i'll give it another shot,its not inside the start button housing thats for sure,i will give the key junction a look/test. thanks.

 

[joncochino]

it wasn't an exposed or damaged wire. the actual bottom
of the fuse box had a hole due to corrosion, that was causing it to blow.
replaced the box casing, we are good to go. pain to find,
but easy solution.

 

[joncochino]

blowing fuses again! now its both the key switch,and the ignition fuse.I don't live in austin,but on the outskirts,and i don't have a truck to haul it around,kinda sucks to have an issue.Even though the buell dealer is like 7 miles away,it's still 7 miles of hoping,or walking the bike there.Ugh! Looked at all the wires again,can't find a bare one anywhere.

 

[ezblast]

If the fuses and fuse box is good and the relay is good, then it is a wire - do continuity tests to find out which wire or switch it is. you can use the wire chart in the back of the manual.
EZ

 

[drlancealot]

Where are the fuses located at on a blast

 

[bust2001]

maybe the circiut breaker?