Correct routing

[KGAWDTSi]

What is the correct routing for this breather line? It does not seem like this is the correct route as where is comes ariund the frame it is pinched.

 

[sewerman]

Remove the zip tie and relay the hose without the kink, Better yet it needs to be rerouted, You will note that it comes out of the motor and goes to the right side of the motor right behind the rear header pipe. If you look behind the pipe don't be surprised to see it melted, I rerouted the hose to the left side of the motor, its a pain but worth it.

 

[KGAWDTSi]

Yeah I looked to where it was coming from and checked as to if it were melted and it was good. I was just wondering the proper routing. I was thinking of rerouting it above the shock mount and then down to the position it is mounted in currently

 

[thrstrmech]

that's stock configuration routing of the breather line

 

[user_deleted]

it's wrong. see the large opening in frame just above shock attachment point? line comes out thru there and terminates approx. 4 inches downstream. held in place at the frame point with black zip tie.

 

[thrstrmech]

mine was in the very same position when I bought her and I've seen several bikes that the line is routed exactly the same, though none had the kink in the line

 

[KGAWDTSi]

Thanks lunatic. They way you describe was the way I was planning to run it.

 

[egobuster1]

thats how mine is ran although I've always said it doesn't seem like the right way to run it