• You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will see less advertisements, have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us.

ECMSPY woes

Buellxb Forum

Help Support Buellxb Forum:

mdiaz2685

Member
Joined
Apr 3, 2016
Messages
5
Hello,

I am having shut off issues while riding the xb12s after an hour or so. Reading other forums sections the issue points to the fuel pump. I "donated" money for rights to download and use the ECMSpy. I was hoping to use the active testing features to test the fuel pump and other aspects of the bike. While executing the active test for fuel pump, I can hear the pump activating and see a progress Windows pop up. Minutes later, the progress window disappears and I cannot find any sort of test results. Does any one have experience with this issue?
 
It's not a smart diagnostic test. All it does is turn on the fuel pump so you can test fuel pressure with a gauge.
 
Reading other forums sections the issue points to the fuel pump.

and what are the "issues" other than shutting off after 1 hour of continuous running? a dying fuel pump gives tell-tale signs of it's imminent demise. they're subtle but they exist.
 
Lunaticfringe,

Prior to shutting off the bike start sputtering, the left side seems to be hot, and once the bike stalls it doesn't turn on for a while. The bike also struggles WOT.
 
Lunaticfringe,

Prior to shutting off the bike start sputtering, the left side seems to be hot, and once the bike stalls it doesn't turn on for a while. The bike also struggles WOT.

check that the tank main vent tube is not obstructed or pinched. it runs from the top right corner of tank where it attaches to vent fitting over top of the airbox inner cover, down left side of same, and terminates down near the fuel pump to atmosphere. check it. check the fuel pump connector and ground wire. in addition to what you mentioned i've found that these pumps on the way to death-row do the following: after sitting for several days or longer and going into start mode they'll emit a high pitched whine for a few seconds....bogging in upper gears when rolling on throttle....bogging when coming out of turn in a higher gear and rolling on throttle.
 
check that the tank main vent tube is not obstructed or pinched. it runs from the top right corner of tank where it attaches to vent fitting over top of the airbox inner cover, down left side of same, and terminates down near the fuel pump to atmosphere. check it. check the fuel pump connector and ground wire. in addition to what you mentioned i've found that these pumps on the way to death-row do the following: after sitting for several days or longer and going into start mode they'll emit a high pitched whine for a few seconds....bogging in upper gears when rolling on throttle....bogging when coming out of turn in a higher gear and rolling on throttle.

Thank you, Lunaticfringe. Your reference on the high pitched whine is what I am also experiencing in a higher gear. The other threads mentioned that removal of the fuel can be done without removing the swing arm. Have you had the pleasure of removing the fuel pump?
 
Last edited:
Its pretty easy, theres a drain plug in the fuel pump base plate (left bottom of frame/tank). You can mold a funnel from tin foil to keep things clean.

You'll need to support the bike from the bottom, ahead of the swing arm, because you will be disconnecting the bottom of the rear shock to let the swing arm hang down. That will give you enough clearance (barely) to remove the pump. Try blue tape on the swing arm to stop any scrapes you might get.
 
Back
Top