Feeler - Round LED lights for the Bueller's or other bikes

[dkaar]

I was looking for circle LED blinkers to match our Buell headlights. I really didn't find much under $70 so I started looking for a company to make them up for me. Below is what they came up with. They have a metal housing and are built really well in my opinion. I have the opportunity for the company to make more sets of these LED lights. They have 18 LED's in them. The LED sticks out slightly from the base but there is a seal so the elements don't get in. I am trying to feel out if anyone would be interested. The more, the better price. I want to donate 10% of the profit to the buellxb.com forum as well. I am not sure if all this will work out, but wanted to see what you all think.

Price is going to be ~$45 plus $6 - $7 for shipping.

 

[levi]

I'd really like to see a set on a bike. I need my blinker to be a weaponized grade of brightness to counteract the very bright sun in traffic.

Would it be too much of a bother to install them and take us some pictures outside?

Thanks


Levi

 

[shopking68]

+1 for pics on the bike

 

[dkaar]

I will be putting my set on this week sometime. I will post up pics when done. They will only be on the back at this time though. I wasn't planning on doing fronts, but probably will when I run the batch to be made up.

 

[dkaar]

Good news folks!!! Price is going to be $32.60 plus $7 ($4.95 for shipping, $.19 for delivery confirmation, $.15 per label, and $1.75 for insurance). Shipping will be USPS priority flat rate with delivery confirmation and insurance. I will get pics up as soon as I can.

 

[ronmetzler]

I would def be interested as well

 

[BuellerPilot]

Might gain more interest if the actual bulbs and it's PC board were recessed into the housig rather than protruding out of it. A lens cap would be a good idea too.

~Mike.....

 

[dkaar]

Mike-

Funny you say that, I am working on that with them right now! Might raise the price some but we will see. Here are pics on the bike.

 

[ronmetzler]

will these fit for the front turn signals?

 

[dkaar]

Yes, they will fit for fronts as well.

An update on the redesign of the LED panel being pushed in farther. I have to purchase a minimum of 500 for them to redesign the casing. It was an "off the shelf" part that were going to use for the original. But the panel doesn't have enough room to slide back that far. So, I need to decide if it is worth going this route or just to pass on the whole idea for now. Cost will also go up by $2.44 per pair.

Thoughts?