Flowmaster?

[d_adams]

So you're going to use this? I'm just assuming since it's the only 2.5" ID stainless one they have available. Just for reference, mine are 2" ID, 3.5" OD and nowhere near that long.

http://www.dynomax.com/mufflers.php?muffler=racebullet


4-in Round total length, 16.5 shell length, 12 inlet/outlet, 2 1/2

And you're comparing it to this?

Just a single 4" round would be more like a jardine, not one of mine, thx.

 

[thuren67]

Sorry if I affended you dean. Not my intention.
I will say it will be like a dynomax bullet. Do not compare it to a keda.
Just another guy in his garage with time to kill and a syncrowave tig to play with.
Cheers

 

[snrusnak]

What is the diameter of the pipe/muffler you'll be using? You'll want to use ~2" for best performance if it's going to be a single. If you do dual mufflers you'd want to go a little smaller, maybe 1.5" or 1.75" just as a rough guess.

I'm going to be modifying my muffler in about 1-2 months and it will basically be a 2" pipe through the gutted muffler. Going to use a perforated pipe to help quiet it. I plan to dyno tune mine, but not until after I ceramic coat my header and put a larger TB on. So needless to say I won't be doing before/after dyno comparisons.

 

[d_adams]

No offense taken, just clarifying what you're doing.

 

[jcoledawg]

So , I'm new to the forum and wanna say hello all first off secondly I'm wondering the flowmaster is it the same size as the magnaflow , from what I read the magnaflow almost fits right into the bracket with just a little grinding .

 

[d_adams]

This. (flowmaster)

vs this. (magnaflow 11148)

Ground clearance, especially over a speed bump. That flowmaster is probably a 5" oval can, so it's losing 1.5" in clearance for sure. The magnaflow is only 3.5" thick and 7" wide.

Want one? I've got one powdercoated satin black, it's ready to ship right now, $450.

 

[thuren67]

How much shipped

 

[thuren67]

The cans range from 4 to 4.5 inches. They are thicker then a magnaflow for sure

 

[d_adams]

In the US, $450 shipped. I can send it out Monday.

 

[Cherryskullz]

Just want to point out that the picture of me with the flowmaster on the bike... my bike is lowered, so thats not really a good picture to go by for ground clearance.

 

[d_adams]

Can you measure it from top to bottom? I'm curious as to what it is now.

 

[thuren67]

Dean a super 10 series is 6.5 long by 9.5 wide by 4 thick
Due to the width I planned to run a custom rear mount so it may be able to mount a hair higher.

 

[thuren67]

http://www.summitracing.com/parts/DTC-776-14252/
This one is 4.5 thick but appears that it may fit the mount very well and is 1 inch shorter overall then the 11148