I've tried to contact gpi customer service but they won't answer or return my call. I have a set of stands and I can't for the life of me figure out how to get the front triple tree lift attached to the lower stand. Can someone tell me how to put this thing together?
GPI Stand Help
- Thread starter dallasb
- Start date
Help Support Buellxb Forum:
Miami78
Well-known member
- Joined
- Dec 7, 2009
- Messages
- 1,677
Here is a pic that shows it somewhat...
Basically though, the big round pin goes through the joint where the triple tree adapter meets the lower stand, I routed mine from inside to outside for adequate clearance), then coter pin it in place and tighten the black tension screw. The height is adjustable with the smaller pin, and coter it in place when you find the height that works for you. It's floppy till you get the pin in the triple tree, then it uses leverage to lift the bike up and is solid as a rock.
Basically though, the big round pin goes through the joint where the triple tree adapter meets the lower stand, I routed mine from inside to outside for adequate clearance), then coter pin it in place and tighten the black tension screw. The height is adjustable with the smaller pin, and coter it in place when you find the height that works for you. It's floppy till you get the pin in the triple tree, then it uses leverage to lift the bike up and is solid as a rock.
Well the snow finally melted and I tried to put on the front stand with no success. The problem that I'm having is with clearance issues with the front fender. I took off the top piece and without the pin it in tried to line the holes but but it bottoms out on my front fender before this can be done. Any suggestions?
Similar threads
