stang65pony
Well-known member
- Joined
- Feb 8, 2010
- Messages
- 803
dumb question but when looking at this;
To reset an 08+ Buell, do the following:
1. Turn on the key.
2. Set the kill switch to the run position.
3. Don’t start the engine. Rotate the throttle from fully closed (gently forced closed) to fully
open (gently held open), and then back again to closed (gently forced closed).
4. Repeat 3 times. Hold each position (fully open, fully closed) for 1 full second.
5. Turn the key off and on.
6. If you connect to Directlink, a fully closed throttle should indicate 3.7 to 4.2 degrees. If it
doesn’t, repeat the above steps.
when it says "repeat 3 times" is that 3 more times after the initial closed to open to closed throttle? or 3 times total?
To reset an 08+ Buell, do the following:
1. Turn on the key.
2. Set the kill switch to the run position.
3. Don’t start the engine. Rotate the throttle from fully closed (gently forced closed) to fully
open (gently held open), and then back again to closed (gently forced closed).
4. Repeat 3 times. Hold each position (fully open, fully closed) for 1 full second.
5. Turn the key off and on.
6. If you connect to Directlink, a fully closed throttle should indicate 3.7 to 4.2 degrees. If it
doesn’t, repeat the above steps.
when it says "repeat 3 times" is that 3 more times after the initial closed to open to closed throttle? or 3 times total?
