Ignition Disassembly

[Renegade]

How do I disassemble the ignition? I need to get the ignition cylinder out of the ignition housing, so I can swap them (did an R to S front end swap).

 

[Negative]

There should be two screws that hold the actual electrical switch to the bottom of the key cylinder ... and two "tamper resistant" torx screws that hold the key cylinder to the upper triple clamp ... hope that helps ...

 

[Renegade]

The ignition assembly is already off the bike. I need to swich the lock cylinder out of the ignition itself....

 

[Renegade]

 

[thrstrmech]

any luck with your friend about the locksmith?

 

[Negative]

There should just be two little screws on the bottom of the cylinder to change out the lock cylinders then man ...

 

[Renegade]

any luck with your friend about the locksmith?

Robin - I'm not going to call him until Monday. Don't want to bother him on a long weekend.

 

[Bum8leB]

I am gathering parts to do same swap. Where are you going to mount key switch when done. I am staying with bolt fairing if I can. So far looks like lightning bars will clear windshield. I am looking for ideas on mounting key.

 

[thrstrmech]

cool, understood...

 

[Buelet]

Did this get figured out? I'm doing an S to R swap right now and would like to just swap the ignition switch internals as well (tumbler assembly) if it's possible.

Anyone?

 

[Renegade]

Never figured it out. I ended up swiching back to my R front end after rubbing through wires in the wiring harness a couple times. Got fed up with it, LOL.

 

[stevengeorgia]

How did you make captain, Relegader?[confused] Chit, Man...That's EASY