Just installed the race ECM and K&N...

[thunderstormgrowl]

Edipis, are you sure it will work on my 2010?

 

[rc3094]

Do you need the race ecm or can the stock ecm be reprogrammed with the cable and ecmspy?

 

[bolt08]

i read somewhere 08 models can be done at home this true?

See below:


To reset an 08+ Buell, do the following:
1. Turn on the key.
2. Set the kill switch to the run position.
3. Don’t start the engine. Rotate the throttle from fully closed (gently forced closed) to fully
open (gently held open), and then back again to closed (gently forced closed).
4. Repeat 3 times. Hold each position (fully open, fully closed) for 1 full second.
5. Turn the key off and on (only once, not repeatedly).

Copied from http://www.technoresearch.com/Manuals/Buell-T ...

 

[Stevenc150]

Do you need the race ecm or can the stock ecm be reprogrammed with the cable and ecmspy?

Pre-'08 bikes have ECMs that can be reprogrammed or flashed - including burning a Race EEPROM onto a stock ECM.

'08-newer bikes, for now, the ECMs are adjustable with the use of Directlink only.