BeDaring08
Well-known member
- Joined
- Dec 28, 2009
- Messages
- 321
Not 100% finished but u get the idea. Still need to mod/make a passenger seat cover. Heres what i did in a nut shell:
1. Shorten the sub frame about 2 inche
2.Moved the bar and seat latch up a inche
3. Narrowed the rear of the frame about a inch
4. Narrow the rear plastic tell it lined up with the frame, Sectioned about a half inch out the middle, so the plastic came up flat with the frame. Cut the bottom part off the front (the part that matches up with the frame).
5. Cut a good 5 inches off the rear end.
6. New under tail and flat leds lights.
7. Still needs finishing but its rideable
1. Shorten the sub frame about 2 inche
2.Moved the bar and seat latch up a inche
3. Narrowed the rear of the frame about a inch
4. Narrow the rear plastic tell it lined up with the frame, Sectioned about a half inch out the middle, so the plastic came up flat with the frame. Cut the bottom part off the front (the part that matches up with the frame).
5. Cut a good 5 inches off the rear end.
6. New under tail and flat leds lights.
7. Still needs finishing but its rideable