problem after run over gas

[carpediem88]

I have a firebolt 07 'what happened was this: I was walking when the bike stopped for lack of gasoline. I tried to connect the bike and managed to get to a gas station. filled the tank and left. 10 minutes after the bike started to fail by cutting off the ignition and firing shots through the exhaust. I waited a few minutes and left. But soon after showed the same symptom. I got home with it failing. already switched rectifier, injection nozzles, plugs, fuses, cleaned the fuel pump, swapped petrol and nothing worked. when I go out on the bike after 2 minutes and accelerated stronger, it begins to fail, choke the exhaust and give shots. sometimes it just spins the starter and does not work. When I turn on the bike and cuts ignition button the light turns on and off check after 8 seconds. help please I'm very concerned

 

[06XB12SS_LOVER]

TPS reset?

 

[carpediem88]

've done it. this morning I checked all the wires and found a wire broken from oil pressure sensor . not out to test because the bike is all disassembled. can it be so?

 

[ztied]

Good possibility

 

[carpediem88]

I test the bike and keep the problem. Have a good way to test the ignition coil??? I think cold be it???

 

[rchuff]

How did the fuel pump filter mesh look? That's at the bottom of the pump .

 

[carpediem88]

I check it and clean the dirty
..now looks good. But still the problem

 

[carpediem88]

You guys now how test my coil???? Can the coil Just fail when is Hot? (after walk with bike and acellerate a lot)

I used a multimeter and give 0.006 ohm between midle and booth side pins

Its right?

 

[carpediem88]

Good news... I found the problem. Its the pulse coil... I open the right side there on buell logo and reach the pulse coil.
When pressed the pulse coil the bike becomes fine....

Just Change it or make a way to let it pressed.

I'm very happy... Tks for the helpers

 

[user_deleted]

that is the cam position sensor. not to be confused with older sportster igniter coil. if yours is bad it should have dumped an error code into you ecm activating your CEL(check engine light). code must be cleared.