RR ign sys fault?
- Thread starter buellxb99
- Start date
Help Support Buellxb Forum:
thrstrmech
Well-known member
have you pulled codes yet? error ignition system? I'm not familiar with the 1125's so don't know where to begin to try and help
Hold both the toggle and mode buttons down while turning on the key. Toggle through the menus, the active DTC's will show up first if there are any. Need the number code to tell you what the problem is, ie; P2303 etc.
Comm error is a bad connection between the ecm and the IC.
p2303 is the rear ignition coil, circuit low
61005 I didn't find, but low fuel sys err is indicative of what the problem is, either low pump pressure or bad sensor.
P1047 is too wide of a spread between the front and rear O2 sensor, it's greater than 25, you have a stock ecm in the bike with an aftermarket exhaust, it will not go away unless you either replace the ecm with a race unit or tune the stock one to match what the exhaust needs.
That many errors, I'd look at charging the battery first and foremost, you may have a weak one that's causing other problems.
p2303 is the rear ignition coil, circuit low
61005 I didn't find, but low fuel sys err is indicative of what the problem is, either low pump pressure or bad sensor.
P1047 is too wide of a spread between the front and rear O2 sensor, it's greater than 25, you have a stock ecm in the bike with an aftermarket exhaust, it will not go away unless you either replace the ecm with a race unit or tune the stock one to match what the exhaust needs.
That many errors, I'd look at charging the battery first and foremost, you may have a weak one that's causing other problems.
.. then i will buy a new batery. 2700 miles in 4 years it probably didnt get ridden much thank you.Similar threads
