self diagnostic

[qhrjsdl]

just turn on key and engine run red switch (not start) and disconnect jump wire

is that all? or do I need any special cable?

http://www.buellxb.com/Buell-XB-Forum/Buell-Firebolt-XB12-XB9/Just-got-my-xb12r

 

[anrkizm95]

no cable needed just the jumper and follow the instruction on the link below
http://www.bcrider.com/DDFI.html

Code No. Fault Condition
11 Throttle position sensor
13 Oxygen sensor
14 Engine temperature sensor
15 Intake air temperature sensor
16 Battery voltage
21 inter active muffler control
23 Front fuel injector
24 Front ignition coil
25 Rear ignition coil
26,27 clutch and neutral switch
32 Rear fuel injector
33 Fuel pump
34 iac
35 Tachometer
36 fan voltage
37,43 speed sensor
44 Bank angle sensor
45 side stand sensor
46 start relay
47 aux power outlets
52, 53, 54, 55 ECM failure
56 Cam sync failure

 

[thrstrmech]

I ordered the pins from New Castle Harley Davidson $1.00 a piece, went to Radio Shack first but no joy there

 

[anrkizm95]

I ordered the pins from New Castle Harley Davidson $1.00 a piece, went to Radio Shack first but no joy there

these in a small size will work.

 

[qhrjsdl]

then just get any wire, and connect with that jack both side. Then, connect 1 and 2 use that wire?

 

[anrkizm95]

then just get any wire, and connect with that jack both side. Then, connect 1 and 2 use that wire?

yep