What did you do for your Buell today?

[Theycallmecrash]

Stupid tire day. The rear done today, the front next week cause of a shipping mistake ggrrr

 

[Jerry C]

Ran the 07 hard on VIR Patriot!

 

[squidbuellie]

finely test rode my 05 after the motor rebuild. next week it's of to get dyno'ed.

 

[Rhino1]

Installed Oberon front LED markers/signals... Waiting on my ZTL2 caliper...

 

[StarWolve]

Passed the salvage inspection at the DMV. Should have a new title inside of 2 weeks.

Also ordered a new muffler clamp from west marine - noticed my front one had broken on one of the test rides. Going through it in the next couple of days and checking/securing all the fasteners.

Also placing a large order with American Sport Bike in the next few days - now that she's passed her inspection, I can start some of the mods I want. Planning on DDM Tuning headlight upgrade, heated grips, GPS mount, and a few other goodies.

 

[freak2180]

Lets see........This time home it will be a full harness swap, Race ECM, Painting and installing pass pegs, and a new Taillight.

 

[PaulPud]

Heres my "Lightningbolt SS" just did the "R" tail conversion.

 

[Zeroflat24]

paupud what kind of tire hugger is that?

 

[oh9bolt]

That is a stock Ss hugger.

Edit: I should say stock size hugger for an Ss.

 

[PaulPud]

Carbon american sport bike? hugger. Dont remeber what brand but its carbon

 

[nyred1125cr]

Changed the oil today. How do you turn off the "service now message" on the dash?

 

[nyred1125cr]

I found it on another forum.

 

[freak2180]

Prepping Baby Girl for a full brain and neurological transplant tonight.......

 

[WALLSXB]

Rolled it into the shed since i've lost interest in riding and needed garage space.

 

[squidbuellie]

Blasphemy

Rolled it into the shed since i've lost interest in riding and needed garage space.

 

[thrstrmech]

 

[squidbuellie]

tried to dial in my buddys bike today....with no real luck. i almost want to throw the crapsickle off a cliff.

 

[squidbuellie]

oh and i also changed the grips and barends on the project bike

 

[Jerry C]

Picking up the X1 from Richmond SuperBike, repaired engine mount, and replaced the rear shock.

 

[GAXB9R]

Its been a long time waiting do to work, but went to Home Depot and bought me a good heater and set my sites on my work shop. Finally finished the chain drive swap on my 03 XB9R. 520 RK xring chain with a vortex sprocket. Installed frame pucks and 5-0 Dro sliders. Also installed the RSS. Now In progress is the tail swap from a bolt to a lightening. Throwing down some primer coats today on the rails and rear light housing. May get finished with them and do some wet sanding. Pictures to come when all is complete.