• You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will see less advertisements, have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us.

wheeling question

Buellxb Forum

Help Support Buellxb Forum:

firebolt3030

Well-known member
Joined
Jan 8, 2010
Messages
62
this may sound dumb i have a 08 firebolt xb 1203cc but i am new to the wheeling and do not have anyone to really show me and trying to get better at it when i pop the clutch and it comes up and going right down lol but what is the easier way to pop up a wheel and what gear or rpms and around what speed i am not saying fast. just a start off at ?
 
You should be able to power it up in first gear, just crack the throttle wide open. I usually do them in 2nd gear, 40mph 4000rpm. I crack the throttle wide open and drop the clutch, comes right up.
 
make sure no matter what you try to always keep your foot over the brake in case it comes up too high and you scare yourself. A tap on the brake will drop it right down. Just experiment and take it slow.
 
Also, pull your arms into your chest when you do it, so if you need to, you can push the bike away from you as well as tapping the brake.
 
Just don't freak out and slam the back brake on. There's a chance it won't be pretty up front
 
I have had a suzuki sv650, gsxr600, and my 1125R and have never done a wheelie. I really don;t want to mess up the bike, but I kinda want to try. Ideas? Not to thread jack!
 
1st gear about 4500, blip the throttle then open it all the way up, you'll get the front end to pop up. if you're trying to do roll ons then just try it from different rpms
 
And dont practice on a road!!! Plenty of video's on you tube to show you how that turns bad real quick!!!!
 
for the clutch it's pretty much the same, just rev up to the the rpm you want, then let out the clutch and it's trial and error for results
 
i got rear end at a dead stop at a 4way stop by a f***ing kid. my only ass end is being replaced and my clutch side. this suck i only have a few more week left to ride in tell winter and it is be fix once again
 
My fat ass couldn't get my front up even if I used a towtruck hooked to the front wheel........ Just sayin.!.!.
 
my skinny ass cant keep my front on the ground. its not till third gear my front tire is finally there lol
 
Back
Top