Winter Mods & Spring Start Up

[boney95]

Just an off the wall question. New winter performance mods include: Open air box, rerouted breather hoses with catch can, and a Twin Tec Twin Tuner. In regards to the Twin Tuner I spoke with Twin Tec and they said to set all of the positions at 5 (since the bike will be lean), minus position 9, set that at 2 or 3, just until I get the bike on the dyno. So my question is, is this bike going to start up in the spring after it's been sitting for so long with these mods? Im sure it's going to run like sh!t until the ECM relearns. I forgot to ask Twin Tec if it's possible to set all positions at 0, so it's not producing any input. Just so it's not too rich at first, and then start fouling plugs (I also sprayed fogging oil into each cylinder for storage, so when I fire her up my plugs are going to get pretty wet). I'm sure this is possible?

Also I figure it's a good idea to run the bike

 

[GatorBuell]

Did you put an exhaust and high flow filter on it already? what is the tuner for?

 

[boney95]

Yeah I've got a Drummer and a K&N on already, ran like this all last summer.

 

[boney95]

I see on my original post my last sentence got cut off. Was going to say, if I do install the open air box I should run the bike for the ECM to relearn before I bring it in to the dyno. Is this correct thinking?