Clutch safety wires cut

[adjwoolley]

I've got a 2 wires cut from the main harness, 2 going to the fuse box, and 2 going to the relay box. All the same color. I've looked through the manual and believe they're for the clutch safety switch which isn't hooked up on my bike (04 xb12r).

Does anyone think this may pose an electrical problem or is it properly disconnected since wires are cut at all three points?

 

[Cosworth]

If you've traced the wires and it is the clutch safety circuit then its not an issue all that circuit does it keep you from starting the bike with it in gear or without the clutch pulled. Just dont try to start it in gear or without the clutch pulled!

 

[user_deleted]

that's a hack job son. before you button anything up better damn sure turn on both the key and the run switch and using a 12 volt test light.....test to see if either wire is "hot". if so completely cover the snipped end and shield it.