diagnostic test

[qhrjsdl]

i connected 1,2pin with jumper cable.

then turn on the ignition keys(not starting engine)


Then! engine service light is blink.

but doesn't show any number on the watch screen.

Am I doing something wrong? or no issue on my bike?

 

[agfish18]

what is at the other end of the jumper cable?

 

[oh9bolt]

Your Check Engine Light should blink and transmit a code. It WONT show a number in the "watch screen".

Here is a website that has some of the codes listed.

Link

 

[qhrjsdl]

where the code should show? isn't it on the screen?

And if my bike has no issue at all, the code shows?

 

[oh9bolt]

No your check engine light should be blinking.

 

[qhrjsdl]

if there is no fault on my bike, how does it blinks? ?

 

[oh9bolt]

Is your cel blinking? If so it should flash a few times rapidly, that is the start before the first digit. It will flash slowly how ever many times it flashes before a longer pause is the first number of the code.

After that longer pause it will flash slowly until a pause that is the second number, then it will flash rapidly at the end. It will do this until you turn the bike off or take the jumper cable out.

 

[qhrjsdl]

yea. engine check light is blinking. It just blinks 12 times fast and repeat and repeat. i have no fault code ?

 

[oh9bolt]

Ok so is there a check engine light on when the bike is running?

 

[qhrjsdl]

nope. not engine is running.

just connected 1,2 pins, and turn the switch on.

then it was blinking 12 times, pause and 12 times and pause repeat.