• You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will see less advertisements, have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact us.

EcmSpy EEPROM's and Maps website

Buellxb Forum

Help Support Buellxb Forum:

awesome site i have a 2000 x1 with a lot of motor work and i've been scouring the web for some maps for my ecm spy does anyone recommend any maps that i should use?
 
help i'm using ecm spy and would like some maps and eeproms to just load up other than factory. i have the bueja120 and the maps of the ecm spy web link on here wont work with my ecm!
 
is the race file for xb9r factory race kit race ecm k&n and buell race exhaust, i have no clue of tuning but would like to richen my bike out seems to run hot,yea i know they are suppose to but a rich engine carbs up and a lean engine burns components out, plus my buddys 12r can shoot foot long flames
 
2009 Buell XB12R
- opened airbox with K&N filter
- D&D style exhaust
- crankcase breather mod
- Wideband tuned AFR for 13.5 cruise, 13.0 WOT
- 600ft above sea level, 70'F avg temp, 50% avg humidity
Would that map(just the map not the whole eeprom) work very well or at all on an 07 with the same modifications??
 
Hey dies anyone happen to have an 09 xb12r, spec ops pipe, and k&n filter map so that I could have a good foundation and then adjust for weather
thanks
Mike
 
hi, i have a 2007 XB12SS with custom straight pipe with airbox delete. does anyone have race maps i can load? my bike isnt running that well at the moment after i played with the AVF and restet TPS.
 
***Hey does anyone happen to have an 09 xb12r, spec ops pipe, and k&n filter map so that I could have a good foundation and then adjust for weather***
I went to the listed website but the only map on the site was for a d&d exhaust.
thanks
Mike
 
Has anyone used the 2003 race map from this site??? I downloaded and compared it to my stock map and the differences aren't as "different" as I thought they'd be.
 
ive been searching high and low FOREVER for a 2009 xb9sx map with K&N intake and Dean Adams exhaust, i pray someone can put one up for me?!?!?!
 
Judging by the lack of reply to the previous poster, us with 08+ xb9's might as well go jump off a ledge.

I have an 08, xb9sx. Just put a hawk exhaust on it, breather box elimination, k&n filter, crank case re-route, and new denso iridium plugs. Now it won't run for more than 45 seconds. I tried manually building a fuel map from a spreadsheet i got from xoptiinside.com and uploaded it and it's still failing.
 
Little bit of an update, turns out the stalling was my own issue. After getting the bike running i uploaded the map i set up and rode it around. It idled rough(as in the rpms were all over the place) while the ecm was learning but it seems fine now.

I got this map from a spreadsheet off of xoptiinside.com and manually added it, filling fields that didn't match because it's a 2008. Any thoughts on whether it's the right map for my mods?

I did not change any other settings besides the fuel map. Initially i changed the minimum AFV but i put that back to stock(which was 60%)

l1ht.jpg
 
two sets of two words

Data Log

Custom Tune.

If you want those as a premade map message dean or xopti. I know xopti has them.
 
Can anyone tell me why there are two 255 tps entries, and should they be the same values? Is there any other value that people change to improve performance, besides the fuel map? Like the afv?
 
Back
Top