SEXT9
Well-known member
With the changes you're talking about, you will probably need a remap. I would do it with a Race ECM and an ECMspy cable.
The o2 sensor is located on the pipe behind the rear cylinder with wires coming out of it. I'm not sure about the Dan Moto exhausts. But most of them replace the muffler assembly at the bottom leaving the header pipes intact.
Your new exhaust however probably will not have use of the exhaust servo. Located on top of the airbox to control the muffler. Most aftermarket exhausts, even the modified exhausts, don't use this feature.
The race ecm has a feature built in to keep it from looking for the exhaust servo and you can simply disconnect the servo or remove it completely. With regards to the o2 sensor, someone will correct me if I'm wrong, but there might be a switch in the software to turn it off as well.
The o2 sensor is located on the pipe behind the rear cylinder with wires coming out of it. I'm not sure about the Dan Moto exhausts. But most of them replace the muffler assembly at the bottom leaving the header pipes intact.
Your new exhaust however probably will not have use of the exhaust servo. Located on top of the airbox to control the muffler. Most aftermarket exhausts, even the modified exhausts, don't use this feature.
The race ecm has a feature built in to keep it from looking for the exhaust servo and you can simply disconnect the servo or remove it completely. With regards to the o2 sensor, someone will correct me if I'm wrong, but there might be a switch in the software to turn it off as well.
