LED relay

[flaya564]

I can't find the one I was looking for. I've search this forum for about an hour looking for the right turn signal relay to buy.

EP-26
EP-27
EP-36

One post said the ep-26 is a direct swap for the oem flasher relay. Is this true?

Which one's are you all using?

 

[Stevenc150]

According to this thread: Upgraded Flasher, the EP-36 should be used.

 

[flaya564]

Well someone had mentioned that the relay you need for the led turn signals is EP-35 from NAPA, same as the one you get from ASB. I plugged in one of the leds in the back (so 2 on the left one led on the right side) and tried it. The left side wouldn't blink (stayed on constantly) and the right side blinked faster. Do you think it would matter to plug in the other side?

 

[dave_xb12r]

I think you should be plugging in the stock turn signal hot wire in there. Then your separate hot and ground into the other inputs. So the relay is triggered by the flashing, making the relay output flash. I think thats right....

 

[dave_xb12r]

ok apparently I don't know what I'm talking about. Kajer needs to chime in

 

[flaya564]

I swapped out the oem flasher relay for the ep-35. just clarifying.

 

[kajer]

I got the one from americansportbike

sorta a slow flash rate on it...

 

[dave_xb12r]

"I'm sad that I'm blinking"..... poor LEDs [sad]

 

[onelogue]

ok apparently I don't know what I'm talking about. Kajer needs to chime in

I know what you are talking about..... [confused]... lol

 

[flaya564]

Okay, to set the record straight.

If you have a three pronged flasher relay and want to use led turn signals, the correct plug and play replacement is EP-36.

It even says led on the relay.

 

[dave_xb12r]

Good job!

 

[whitehorse]

Any ideas on where to buy an EP-36

 

[50dro]

any auto parts store...got mine at Pep Boys

 

[whitehorse]

I went to autozone and bought an EF 36 but it doesn't work. The guy said it should be the sam as the P but I'll check some other auto places.