Remaining Parts for sale (Micron)

[jakestolar]

Alright this is what is left after the part out of my 05 XB12R. Not too much!!! Take a look, see what you want and let me know. I am trying to get this stuff out of the way before the parts come in to fix my 09 XB.

I am wanting $750 + actual shipping for the Micron
$200 shipped for the Race ECM. Other than that make me an offer.

(pictures to follow)

 

[jakestolar]

Micron!!!
Race ECM
Daytona tuner (with directions)
Wind screen (obvious damage shown)
Mirrors (the threads are a bit stripped)
Left riders rear set (bent inward)
rear turn signals
Fan
Cluster
LSS (damage show)
Factory RSS cover (free to good home)
Coil
Air box parts
Wire harness
Throttle body
Rear shock
Front support member
MISC Engine parts. Tell me what you want and I will pull it off!

 

[jakestolar]

 

[ArmyMP09]

PM sent[up]

 

[jakestolar]

Replied Thanks

 

[jakestolar]

All PM's replied

 

[d_adams]

That worn part at the inlet of the muffler will need to be repaired eventually. It's a fairly easy repair though.

 

[SonderMann]

Sorry Jake but I hate you to some extent.
You have killed the bike. I am crying when looking at this MURDER SCENE!!!

Sorry it is too painful for me

Nothing personal... No offence... May be it's just because I do not have any Buell... And every one is like masterpiece for me...

MU-U-URDERE-E-ER

Sorry again...

 

[SonderMann]

That worn part at the inlet of the muffler will need to be repaired eventually. It's a fairly easy repair though.

Nice job D ADAMS [up]

 

[jakestolar]

Hmmm I might go ahead and have that taken care of.
Thanks D-adams

Sonderman, Dunno what to tell ya buddy, shit happens?

 

[d_adams]

Look at both pipes where they go into the front end of the muffler. The wear will be fairly obvious. I think what happens is, it gets pushed or wedged to one side and applies pressure, then the vibrations wear it down. The one I did had a huge wear pattern on the inside of both pipes where they were touching.
Yours looks like it's not too bad yet, but it will continue to wear.

As I recall, the tubing micron used was only about .035" so it's pretty thin to begin with.

 

[thumpin1203]

Hey Jake, did you come to a conclusion as to what the original issue was with the motor?

 

[jakestolar]

Hey Jake, did you come to a conclusion as to what the original issue was with the motor?

Nope something with the push rods &/or timing? I dunno I dont have the time or space to really get into her...

 

[jakestolar]

Forgot to mention I also have a fuel pump

 

[Indy500Blast]

PM sent for Speedo

 

[jakestolar]

replied [up]

 

[jakestolar]

Fuel pump, All air box parts and riders peg pins/springs All sold!

 

[jakestolar]

and speedo is sold

 

[jakestolar]

up

 

[jakestolar]

Anyone want a tranny/ bottom end to play with? Tryn to get this outta the way so I can start putting mine back together!