Rizoma Track 77 turn signal problems???

[dameat]

Just bought an 09 xb12s and it has Rizoma turn signals.Cant get them to work and cant find a wiring diagram to help...Fuses are good and it seems wired properly but wont come on.Any help/ideas would be greatly appreciated...
Thanks Dameat

 

[J_Undisputed]

you using the original flasher or one made for LEDs? Also were the Rizomas you got, terminated for the buell bullet connections or were they unterminated and you had to terminate them yourself?

 

[dameat]

The flasher is the led one and far as terminated or unterminated i dont know...looks like it has all the upgrade wiring pieces needed for those led blinkers.

 

[J_Undisputed]

Ok.. I had a problem with some rizomas I got from an Italian vendor. They came in cheap sealed plastic packaging and I think they may have been meant for another bike. The wires were unterminated when I got them. I put them in and half a click and they the blew out. I couldn't get the money back because i had to splice them into the original leads to route the wires the way i wanted.

I ordered another pair from CJ Moto for a buell. There were already terminated with the bullet connectors and the went right in no problem.

I would check the flasher again. I was using the Grote one sold by American Sportbike. Other people use the EP36 but it has to say LED. So we'll assume you have one of those. Are you using the load adjusters that come with Rizomas or are you running them straight? No signs of life. Not even buzzing sound?

 

[dameat]

Theres a click and the light will come on but not blink.I have an adjuster on each blinker.

 

[J_Undisputed]

If you have the correct LED flasher, I would try it without the adjusters. Between all 4 signals, the load should be ok. If you had the original flasher the adjusters should be used or the they tend to buzz, flash really fast or both. The LED flasher and the signals without the adjusters should be fine. If the flash a little fast, you can always add and adjuster or two back on to slow it down or maybe want to remove the resistor/adjuster one at a time and see if that makes the difference.