Parts cross reference thread

[user_deleted]

Hello all, I am new here but this thread has helped out tons, thanks! I was wondering if anyone had a cross ref part number for the 1125 rear O2 sensor HD p/n P0277.1AM . I know its a Bosch unit but I can't make out the number :up:

03 XB9
08 1125
09 XB12XT

you listed 03 and 09 XB's so i'm assuming here that this 1125 O2 sensor you want to "cross-over" is the same reference as those XB models you listed. if that is the case then here's your cross reference list as follows:

Bosch 12014
Denso 234-1001
NTK 21002

 

[Bubbahotep]

Thanks Lunatic, the Bosch 12014 is the sensor for the older XB's and has a short single wire( avail Carquest $20) but the 1125 has much longer wire and the body of the sensor is about half as long. I guess I could splice the wire but a factory connection would be desirable...

 

[kc8gkd]

Hi, I am having a hard time finding rear wheel bearings for my 2003 Buell xb9r. I see part# 6006-2rs what brand is this # for? Thanks.

 

[midway]

I am having a hard time finding rear wheel bearings for my 2003 Buell xb9r.

http://www.allballsracing.com/

Enter year, make, model and away you go. I put these front and rear no problem, good service, good product.
Contact if you are not sure... [email protected]
They are blue, not black or orange in case you have need to match wheels. Best replace them both front and rear together anyway right? Mind the precious spacers, they need to meet the specs for width (end to end) un-crushed and perfect in case somebody over torqued them you should be fine to reuse. If not they're available for 10-11 bucks a piece.

 

[user_deleted]

Hi, I am having a hard time finding rear wheel bearings for my 2003 Buell xb9r. I see part# 6006-2rs what brand is this # for? Thanks.

your choice of rear wheel bearing is as follows and you will need 2 for your 2003 XB. the all-balls come 2 per kit:
6006-2RS-1-C3 *****do NOT try C4.....will not fit
factory part # is E0005.02A8B 2 per part #
drag specialties----6169366
all balls # 25-1627
E0005.02A8B in fact contains pair of 6006-2RS that you listed.

you're welcome

 

[TPEHAK]

2009 Buell XB 12 Scg injector o-rings (both upper and lower):

Inside diameter: 7.9 mm (0.3110 in)
Outside diameter: 14.9 mm (0.5866 in)
O-ring section width: 3.5 mm (0.1378 in)
Material: Viton
Hardness: 70A-75A

https://www.mcmaster.com/#9464K543
https://www.mcmaster.com/#5267t166/=19qshx9


2009 Buell XB 12 Scg IAC o-ring:

ID is about 19.29-19.39 mm
Section width is about 1.89-1.91 mm
Durometer: 70A-75A
Material: Viton

https://www.mcmaster.com/#9263K631
https://www.mcmaster.com/#5267T29

 

[TPEHAK]

I'm gonna add this to the thread:

'08+ XB tps sensor, Duralast, can get at autozone or most auto parts stores. used on BMW's, cars & bikes. mine was $80.00 @ autozone. easy to install, you will need a super small 7mm wrench

2009 Buell XB12Scg TPS4129 $23

http://www.ebay.com/itm/Throttle-Po...e=STRK:MEBIDX:IT&_trksid=p2060353.m2749.l2649

 

[TPEHAK]

Starter gaskets: Cometic C9312 https://www.amazon.com/gp/product/B0012TRJVQ/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Top end gaskets 2007-2010: James Gaskets Kit #JGI-17049-07-X https://www.amazon.com/gp/product/B009XIOZ0G/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Top end gaskets 2003-2006: James Gaskets kit #JGI-17049-04-X https://www.amazon.com/gp/product/B009XIOZ6U/ref=oh_details_o01_s00_i00?ie=UTF8&psc=1

Oil filter: KN-177 https://www.amazon.com/gp/product/B000E28CCC/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Air filter: KN BU-9003 https://www.amazon.com/gp/product/B000E28J0C/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Engine oil plug o-ring/ primary oil plug o-ring: Harley #11105 https://www.amazon.com/gp/product/B00GWVB7L2/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Engine oil/ primary case oil: Mobil 1 96936 20W-50 V-Twin Synthetic Motocycle Motor Oil https://www.amazon.com/gp/product/B000SKV4T8/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Front fork oil: Belray 99330-B1LW High Performance Fork Oil - 15W - 1L https://www.amazon.com/gp/product/B0045LCE6S/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Brake fluid: Motul 8068HL RBF 600 Dot-4 100 Percent Synthetic Racing Brake Fluid https://www.amazon.com/gp/product/B0011E2Y0I/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

2009 Buell XB 12 Scg front fork oil seal+dust seal kit: All Balls Fork and Dust Seal Kit 56-132 41-7180 22-56132 AB56-132 Fork Seal http://www.ebay.com/itm/All-Balls-F...e=STRK:MEBIDX:IT&_trksid=p2060353.m2749.l2649

2009 Buell XB 12 Scg rear brake pads: EBC/FA140HH http://www.ebay.com/itm/EBC-Brake-P...ash=item466173cbe9:g:pZoAAOSw~CFY7~PJ&vxp=mtr

Shifter shaft seal: James Gasket 37107-06 http://www.ebay.com/itm/James-Gaske...ash=item541fe123ca:g:E4oAAOSwxu5ZGcx4&vxp=mtr

 

[TPEHAK]

Front tire: Pirelli Diablo 120/70-17 ZR https://www.amazon.com/gp/product/B000GVALUW/ref=oh_aui_search_detailpage?ie=UTF8&psc=1

Rear tire: Pirelli Diablo 180/55-17 ZR https://www.amazon.com/Pirelli-Diab...keywords=Pirelli+Diablo+rear+tire+180/55ZR-17

 

[TPEHAK]

IAC housing gasket (PN: P0284.5AA) material for 2009 Buell XB12Scg: N-8090 Interface Solutions about 0.79mm thick (0.031") or Aramid/Buna-N Gasket 1/32" thick (you have to cut gasket from this material)

https://www.ebay.com/itm/2-Pc-Inter...ash=item25ce9c1438:g:29EAAOSwUKxYko7Z&vxp=mtr

https://www.mcmaster.com/#9470k26/=19z4apv

 

[TPEHAK]

2009 Buell XB12Scg starter clutch: All Balls HD# 31663-90 https://www.amazon.com/gp/product/B000WJZ4BY/ref=oh_aui_search_detailpage?ie=UTF8&psc=1#Ask

 

[TPEHAK]

2009 Buell XB12Scg intake manifold to cylinder head black gaskets: James Gasket JGI-26995-86-A https://www.amazon.com/Orange-Manif...qid=1509416090&sr=1-3&keywords=JGI-26995-86-A

 

[Joe7Bros]

So here's a cross reference for XB rear brake light switch; this one is from Amazon, but the important part is the 10MM / 1.25 pitch: Goodridge BL Banjo Bolts With Built-In Pressure Switch - Single Bleed - 10mm x 1.25 PBL992-32CH. ; about half the price of the Buell OEM item and free shipping with Prime.

 

[TPEHAK]

2009 Buell XB Clutch plates: Barnett Clutch Plate Kit 306-30-20015 https://www.amazon.com/Barnett-Perf...eywords=Barnett+Clutch+Plate+Kit+306-30-20015

 

[samuelseggs]

Cross-reference parts for xb9sx 2009 front fork?

 

[madisonm55]

Does anyone have the part# for the advance Auto (NOT AutoZone tps213) mustang TPS. There is 2 or 3 options from BWD that all say they fit the 93 mustang gt. There is the EC3314, EC3314P, and EC1016. Trying to stay away from duralast brand.

 

[BruceKoukalaka]

What heads can I use on a Blast? I picked up a 2000 engine and am having troubles finding the correct head and a front belt sprocket (my '01 doesn't seem to fit correctly)

 

[user_deleted]

bruce: see link below. name is lee. he's a great source for blast info. he's also occasionally on here. board name is jetlee. he'll know. also see blast pulley/belt info below. 2000 model year blast was mandatory recall for update belt/pulley upgrade. perhaps yours' was never addressed?

https://buellridersonline.com/forum/showthread.php?t=6693


2000 Buell Blast / P3 (All 2000 recalled and changed to 2001 spec)

Front sprocket 27 / 40218-00Y

Rear sprocket 73T / G0400.T

Belt 135t / G0500.T

3/4" wide



2001-2010 Buell Blast / P3

Front sprocket 27 / 40218-00Y

Rear sprocket 80T / G0420.01A7 / Replace at 15,000 mi

Belt 139t / G0500.01A7 / Replace at 15,000 mi

3/4" wide

 

[Cooter]

Great info Lunatic^^^ Thanks for adding

 

[gargaflute]

Hello

So I read the whole thread and I cannot find a clear answer to what I'm looking for.

I have a 2007 XB12STT, which TPS do I need? The Duralast 4129 or the 213?

Cheers